Göldo Screws for Bass Pickups SB

Screws for Bass pickup

Ordered these to replace the screws on a fender P bass but these are longer and a tiny bit smaller that the stock fender P bass pickup screws.

Just keep in mind to order the correct size for your pickup.

It's too soon to tell if the quality is good.

Works fine, good quality.

I got these because according to the specs they were slightly longer than most standard pickup screws. I have a bass with slightly deeper routing than normal and none of the spare screws I had were long enough to adjust the pickups correctly.

These screws did the trick. They're only 2-3 mm longer but it was enough to get the pickups where I wanted them.

Quality wise they're perfectly fine. Nothing exceptional, they're simply good quality screws.

Carpenters choice.

The Screws were used in an experimental P Bass which I made from Oak! (being a carpenter, I get a lot of good quality off-cuts). When new, being decent quality, the screws drove into the hard wood perfectly. However, about a month later when I came to adjust the height of my pick-ups, two of the screws refused to budge and I ended up rounding the heads off. This was through no fault of the screws but was due to the high tannin content in Oak which can eat steel. As a carpenter I should have realised this earlier. I managed to remove them cleanly with pliers in the end!

In summary;

Good quality screws, perfect for use in normal tone woods, will be buying more very very soon but oiling them well before they go back in!

Oak.... Excellent tone wood, but a bit heavy and likes to eat steel! :)

Good

No problems with them yet. Had for almost a year, no rust.

Perfect for Bartollini pickups

just what I needed, perfect replacement for Bartollini pickups screws

Good quality screws

The finish is nice and they're long enough for most instruments. The heads are pretty sturdy but don't get too excited with your screwdriver or you'll end up ruining them.

Value for money

I bought these to replace screws in EMG jazz pickups which had oxidised over the years (the black screws now had white powdery oxidation on the heads), these are a perfect replacement same length same thickness and same thread, the bass now looks good as new and they fit perfectly!