Lead Foot FS-2 5-stars Reviews

Another great value item

So are you in the ranks of the "remarkably big boned" and do you flamenco dance on your pedals? If not then you won't go wrong with this dual switch unit. It's a plain old 2 x stomp switch through to stereo jack type controller. Features? It has no frills. What frills could there be? It just quietly does the job.

It's a metal centre section with plastic cheeks and looks as robust as it needs to be to give years of service if treated reasonably well.

Why pay more for a name? This does the job and does it well!

Bought to use with kemper and FS-1

I bought this unit along with the GS-1 to pair together on a pedal board for live use with my Kemper Profiling Amp.

I use this unit to swap between profiles and pedals live with 0 Faults. The metal housing is very sturdy and strong. It happily takes my foot beatings when Im on stage pedal dancing between sections of out set.

I've also gone to the length to re-spray the housing matte black so that when the two pedals are side by side they look like one single unit.

For the price, cannot complain at all. Does the Job perfectly!

Does the job.

Switch 1 for channel, switch 2 for gain for me. LED indicators would be nice, as would a beer keg.

It's lightweight, but works without adding noise when switching so all is well.

As a cheapy switch, it does the job just fine. Look after your kit and I don't see why it should fail.

The connector isn't the best, but it isn't subject to much strain so no worries.

Switchy goodness.

Very Good Foot Switch

I bought this Foot Switch to use with my tube amp, to switch between clean and drive chanel and to switch the reverb on and off.

It has a 6.35 mm (1?4 in) stereo jack and two 3 pin 2 positions switches. Because it operates without batteries, It has no indication LEDs (this makes it compatible with more amp models because the on and off state depends on the amp and so it was possible that in some cases the LED will light when effect is off). It is possible to add LEDs but you will need to use an 6 pin 2 position switch.

It is compatible with all the amps that use on/off foot switches.

It will not work with amps that use momentary switches (like "tap tempo" ones).

The case is solid metal, so it is very durable.

Lead Foot

Hey, this is a footswitch, not rocket science but it sure does its job well, reliable and sturdy. The price is about 25% of a Marshall original switch so why not? I have used it on quite a few gigs and it never let me down!

Best value foot pedal

Compared to the other dual pedals available, this does the job at a cheaper price. I had no problems with this pedal after a few months of use, and it's obviously universally compatible with amps which allow it. This is an accessory that probably shouldn't be taken too seriously, and because of this, I recommend this pedal due to its value for money.

Lead Foot FS-2

This switching footpedal does exactly what it is supposed to. It switches between clean, overdriven and boost on my Hughes and Kettner Tubemeister 18. When purchasing I wondered whether the pedal would last. I am pleased to say the pedal has been gigged several times since purchase and used for every practice. The casing and switches seem robust and the cable is a decent length to suit my set up. Why purchase a more expensive branded switching pedal when this one just does the job it's supposed to.