Furman M-10x E 5-stars Reviews

Good

Well packed and in good condition.

Will save you a potential hazard

Does exactly as advertised and helps avoid surges with the balacned power output

Furmanly brilliant

Great product, works as described and the price is unbeatable. Using it for studio purposes, does all I wanted it to do. 10 sockets at the back is great for a 1U unit and the extra one at the front is so convient. Make sure to get an IEC - EU adapter cable for that front one and you'll be super happy!

Plug and forget it even exist!

Typical Furman, install them on your rack, plug all the system there, get your secure feeling without even remember the Furman was there. It is always work like a charm!

It´s necessary in your home studio

It´s quite robust and for me a very good alternative to generate security in your equipment, has enough inputs to feed a home studio and maintains the correct voltage without problems.

It´s also true that it says it eliminates noise, this is not entirely true, if it reduces it, but it does not eliminate it.

Exactly what I needed

All the interference's are gone, I should have bought this before!

Simplicity & security

For the longest time I've used a regular old extension plug and just jammed everything into that, however with my music career growing & having the ability to afford more gear, I decided to get ahead of the curve and invest in a power conditioner. The last thing i'd want is to lose gear to a cheap extender.

It connects to my Neumann kh310's, Kemper, PC & Monitor & honestly i feel so much safer & encouraged to work in my environment now.

Its feature set is limited but then again, it's a simple tool that does a simple job so im not complaining.

Overall, i give this my recommendation.

The best of conditioner

Very good quality and working

Great way to clean up home studios, highly recommended.

This power conditioner rackmount is perfect for setting up a rack with multiple modules and other sound devices and cleaning up the cable management mess that would usually come with these kinds of setups.

I use this for connecting my sound modules and even my PC and speakers in order to make sure there's good protection against electrical surges and to protect these modules from having electrical noise in their audio signal.

There's a certain convenience in having one switch on the front to turn everything on and off so you don't have to worry too much about turning off a power strip somewhere all the way below your desk.

This rackmount unit is actually not too heavy and screws into most racks easily, though it doesn't come with screws included.

If you've got more than ten devices you need to connect to a secure power network, maybe there are other options from Furman.

I'm sure more than one of these units could still work well, I just have no personal experience with that.

Overall, this is a very good deal for the price if you're just starting out as a home musician or just want to secure your devices from sudden power surges.

One small warning: depending on the type of device you wish to connect, finding the correct power cable to fit with it in stock MAY be difficult. Far from impossible, it may just be a bit of a frustrating search initially.

Furman as always

I use M-10x E in a recording studio. It supplies power for preamps and converters. We're super happy with it. I also use a higher version of Furman in my home studio. I can't tell the difference between them. Just consider if you need lambs or voltage meter on front side. Great products!

Nice Product

I've bought it for my homestudio. I had some noise problems because I'm in a flat and after I've connected the entire studio (Midas Mixer, compressor, eqs, soundcards, speakers, 2 Pcs... lots of stuff) to it, the noise problems are finally gone! The sockets in the rear seem a bit flimsy but the overall product seems very nice. Would recommend to buy it for sure! great for the price

Great conditioner

I use this to protect my hardware gear and it works flawless as expected. Excellent price and saves a ton of insurance costs for unprotected equipment. A must for your setup.

Good power suply

This is a basic and classic supply and conditioner unit for your rack equipment. This is for those who do not want to repair their equipment due to power surges. I use for guitar rack equipment: preamp + poweramp + processor. Works flawlessly, I do not hear any noise of the mains

Don't Fight The Power

I wanted one of these for three reasons:

1. I wanted to supply power to the units in my rack case without a tangle of cables or .

2. I wanted to minimise/eliminate any mains noise and hum.

3. It looks cool and professional.

If you want to power multiple valve power amps, you'll need something higher up the range, but if you've ever played in a club with crappy, buzzy mains power, these are great.

Mine powers my AxeFX III, Helix Rack and a Scarlett 18i20 with just one power cable to the case. The switch on the case means I can turn everything on and off easily. Fewer cables running back and forth makes things safer, neater and (arguably) sound better. There's even a socket on the front if you need one.

There are models with added lights, bells and whistles, but if you don't need the extras, this does just fine.

Best Power Conditioner

I purchased this for my rack in church and it works great.

manages the power very well. It is better than the other power conditioners I have used

the only shortfall is the lack of screen but I am sure I could get that with a few extra bucks.

I love this product and will certainly recommend it to others

Highly recommended.

I use this in the rehearsal room, no more troubles with unstable electrical networks.

Power Conditioner

Furman is known for their awesome studio gear and when it comes to their power conditioner M-10X, The quality is there.

Furman

Does its job. Good price, good reputation.

Excellent value for money

Obviously not the top of the range power conditioner but even at this low price, everything runs smoother and without any electric noise

Good device for good price

For a relatively low price you'll got the device what removes all hums from power supply of your recording/live setup. I also have Furman PL-Plus CE and they both works great.